|
|
|
ALPHA 8® DRIVE-ON COATING SYSTEM FOR TRAFFIC AREAS |
|
|
|
|
|
ALPHA 8® DRIVE-ON COATING is much tougher than most elastomeric acrylic coatings, providing superior protection against physical abuse. It provides long-term protection and waterproofing over concrete surfaces such as driveways, parking lots, concrete decks and bridges. ALPHA 8® DRIVE-ON COATING forms a virtually inseparable bond with concrete surfaces and will not peel away due to repeated exposure to heat generated from tire friction. Ace Coating Company uses only the highest quality raw materials to produce ALPHA 8® DRIVE-ON COATING, considered to be one of the finest acrylic elastomeric coatings available on the market. Production is rigidly controlled to assure consistent quality in every batch made. ALPHA 8® DRIVE-ON COATING provides outstanding resistance to the effects of weather, temperature changes, ultraviolet radiation and mildew. It is designed to retain long-term flexibility and breathability for many years and is easy to clean, safe to use and solvent-free. ENVIRONMENTALLY SAFE : ALPHA 8® DRIVE-ON COATING contains no hazardous chemicals and is nonflammable. There are no clean-up or pot-life problems as the coating requires no dilutions or additions. EASE OF APPLICATION : Brush, roller or spray. All surfaces must be clean, dry and free of dirt, grease, oil or other contaminants which would interfere with proper adhesion. LIMITATIONS : ALPHA 8® DRIVE-ON COATING should not be applied at temperatures below 50 degrees F or if weather conditions would not permit drying before rain, dew or freezing temperatures. Cool temperatures and high humidity retard cure. |
|
|
|
|
|
ELONGATION ( ASTM D412 ) ...................................... 480 % TENSILE STRENGTH ( ASTM D412 ) .............................. 415 PSI HOT TIRE PICK-UP RESISTANCE .................. EXCELLENT (NO LIFTING) DIRT PICK-UP RESISTANCE ................................... EXCELLENT COLOR STABILITY ........................................... EXCELLENT VISCOSITY .............................................. 105 - 115 KU SOLIDS BY WEIGHT ( ASTM D1644-75 METHOD A ) ........ 66% ( + / - 1% ) SOLIDS BY VOLUME ( ASTM 2832 ) ..................... 52% ( + / - 1% ) WEIGHT PER GALLON ........................................... 12 LBS. CLEAN-UP ...................................................... WATER RECOAT TIME (DEPENDING ON TEMPERATURE & HUMIDITY)..NORMALLY 2 - 8 HRS |
|
|
Ace
Coating Co., Inc 8333 Case Street,
La Mesa, CA 91942
(800) 672-7100 www.acecoating.com Copyright | Contact Us |
